Estimation of Rotor Type Using Ferrite Magnet Considering the Magnetization Process

Kyu Seob Kim, Min Ro Park, Hae Joong Kim, Seung Hee Chai, Jung-Pyo Hong

Research output: Contribution to journalArticle

4 Scopus citations

Abstract

This paper deals with the post-assembly magnetization process of motors using ferrite permanent magnets (PMs). In order to meet the needs of mass production, most motors are magnetized post assembly. However, increasing complex shapes are required to maximize the flux of PMs. As a result, certain locations in the magnet are not fully magnetized by the magnetizing fixture due to insufficient magnetomotive force. Therefore, an analysis concerning the post-assembly magnetization is needed. In this paper, the concentrated flux spoke-type synchronous motor is analyzed with regard to the magnetization process. Owing to more flux, this motor is designed as a V-shape PM. Therefore, it is not fully magnetized according to magnet shape. By identifying the effect of the magnet shape, the magnetization level is compared by the amount of flux linkage between post assembly and at full magnetization. Finally, the back electromotive force is estimated by the post-assembly magnetization method according to the magnet shape.

Original languageEnglish
Article number8101804
JournalIEEE Transactions on Magnetics
Volume52
Issue number3
DOIs
StatePublished - 2016 Mar 1

Keywords

  • Ferrite magnet
  • magnetization level
  • magnetization processes
  • magnetization processes
  • post assembly magnetization

Fingerprint Dive into the research topics of 'Estimation of Rotor Type Using Ferrite Magnet Considering the Magnetization Process'. Together they form a unique fingerprint.

  • Cite this